The crimping tool is a tool designed to crimp or connect a connector to the end of a cable. For example, network cables and phone cables are created using a crimping tool to connect the RJ-45 and RJ-11 connectors to the end of the cable.At FiberStore,we supply some crimping tool to help you to made your need cable.So,I will tell you 9 steps to crimp a RJ45 Plug.
1, Stripping
The twisted pair twisted-pair wire stripper plastic sheath stripped of 2-3cm (Figure 1);
2, Winding Displacement
Untwist the paired wires and separate them. Then arranged the green line and the blue line in the middle position, and the orange line on the brown line on the outer position, the formation of the left orange, blue second from left, left Three Green, fourth from left brown line on the order (figure 2);
3, Cable Management
Carefully peel each line (open twist), and the line core T568B standard sort, especially to white and green cores from the blue and white blue line on the cross to the 3rd position, the line core straightened flatten, tight squeeze to straighten out (close to) in one direction (figure 3);
4, Cut
The the bare twisted-pair core pressure pliers, wire cutter, diagonal pliers and other tools neatly cut, leaving only about 13mm in length (figure 4);
5, Insert
Single-handedly crystal head, pinch the thumb and middle finger and index finger pointed at the direction of the crystal head metal pins facing up, shrapnel down. The other hand pinch the twisted pair, forced eight twisted pair wire sequence inserted into the crystal head slowly, and has been inserted into the top of the groove (figure5);
6, Check
Check the front of the crystal head to see the correct line sequence; Check crystal head top view 8 cores are the top to the top (figure 6);
7, Crimp
Checked and verified, the RJ45 Plug pushed into the pressure line clamp slot clenched crimping pliers, will be prominent on the outside of all the pressure pins crystal head into the RJ-45, RJ-45 crystal head connection is completed ( figure7-9).
8, Make A Patch Cable
Using the same standard install crystal head, the other side of the twisted pair to complete the production of direct access to the network jumper. The other side of the T568A standard installation crystal head, completed a crossover cable production.
9, Test
With a simple line in the training stage of the test device or toolbox integrated wiring sequence tester to test the network, there will be through straight-through cable crossover cable by open circuit, short circuit, reverse polarity, jumper display results. RJ-45 crystal head protective pouches prevent jumper pulled cause poor contact before you connect RJ-45 crystal head, crystal head To use this pouches, need pouches inserted in the twisted-pair cable, the connection then put pouches.
Note:
1,Stripping can not cut through the insulation of the twisted pair wires;
2, pay attention to the pressure line intensity should be moderate
Learning this article to know how to crimp a RJ45 Plug and some note,do you want to Crimping your own RJ45 plugs will allow you to create cable lengths specific to your needs. Hurry up to FiberStore to buy the tool and cable to try,our product always has a high quality and low price.